Seat Leon >> Repairing the puncture

To repair the puncture, once the preliminary tasks are done, follow these steps.

Apply the sealant
 – The instructions for using the sealant correctly are on the packaging

Inflate the tyres.
 – Remove the compressor and hose.
 – Tighten the fastening nut onto the tyre valve.
 – Connect the compressor power supply to the 12 Volt socket.
 – Connect the compressor and check the tyre pressure with the pressure gauge.

Finish the repair
 – Remove the compressor hose from the valve.
 – Check the cap on the tyre valve.
 – Disconnect the compressor from the vehicle mains.
– Put the tools back in the luggage compartment.

Note
 The compressor should not operate more than 6 minutes

    Preparation work
    What you must do before changing a wheel. – If you have a flat tyre or puncture, park the vehicle as far away from the flow of traffic as possible. – Apply the handbrake firmly. – Engage the ...

    Fuses
    ...

    See also:

    Exploded view - tailgate
    - Gas strut retaining bolts 2 off Screwed to the body 22+- 2 Nm - Gas strut - Sealing plug - Rear lid - Lower tailgate trim Install and remove - Upper tailgate l ...