Seat Leon >> Interior light / front reading lamp unit: removing and installing

SEAT Leon Service and Repair Manual / Electrical system / Lights, bulbs, switches - interior / Controls / Interior light / front reading lamp unit: removing and installing

Special tools and workshop equipment required

  • Lever - U30800-

Removing

  • Switch off ignition and all electrical consumers.

Vehicles without access and start authorisation system

  • Remove ignition key, if fitted.

Vehicles with access and start authorisation system

  • Store the ignition key outside the vehicle to prevent the ignition from being switched on unintentionally.

Continued for all vehicles

  • Unlatch the snap tabs -arrow- with the lever - U30800- or a suitable screwdriver, and remove the back interior light/reading light from the roof trim taking care of the connection lines.

  • Release and detach connector -arrow- and remove rear interior light - W43- .

Lights, bulbs, switches - interior

  • Release the 4 locking lugs -arrows- each of lens -1- and remove lens from interior light by lifting it straight upwards.

  • Remove bulb -1- from holder.

Installing

Installation is carried out in reverse order.

    Removing and installing interior light/ reading light (front)
    Removing and installing interior light/ reading light (front), without alarm system Special tools and workshop equipment required Lever - U30800- Removing Switch off ignition and all el ...

    Button for tyre pressure control unit - E226- : removing and installing
    Special tools and workshop equipment required Lever - U30800- Removing Switch off ignition and all electrical consumers. Vehicles without access and start authorisation system Remo ...

    See also:

    Biodiesel
    Only vehicles approved by SEAT or retrofitted for use with biodiesel (PR No. 2G0), may be operated with biodiesel. CAUTIONIf biodiesel is used in a normal engine then the fuel system will ...