Seat Leon >> After changing a wheel
After changing the wheel there are still tasks to complete.
– Put the tools and jack back in the luggage compartment.
– Place the wheel with the defective tyre in the luggage compartment
and secure it.
– Check the tyre pressure of the newly fitted tyre as soon as
possible.
– Have the tightening torque of the wheel bolts checked as soon as
possible with a torque wrench. The prescribed torque is 120 Nm.
Note
• If you notice that the wheel bolts are corroded and difficult to turn when
changing a wheel, they must be replaced before having the wheel bolt torque
checked.
• In the interest of safety, drive at moderate speeds until the wheel bolt
torque has been checked.
Changing a wheel
Change the wheel as described below
– Pull off the hub cap. See fig. 154.
– Slacken the wheel bolts
– Raise the car with the jack in the corresponding zone
– Take off the wheel and t ...
Wheel trims
The wheel trims must be removed to gain access to the wheel
bolts.
Fig. 154 Changing a
wheel: Removing the
wheel trim
Removing
– Insert the extraction hook from the tools into the designated ...
See also:
Repairing steering box
- Right track rod ball joint
Marked with "A"
Removing and installing
Installation position
Corresponding to -
Electronic parts
catalogue "ETKA"
- Nut
To tighten and l ...